136
Chapter 12—Surround Pan
When you select one of these Surround modes, each surround channel signal is output as
the Bus Out signal specified on the DIO/Setup | Surr Bus page (see page 138).
The following table shows the factory-default Surround Channel to Bus Out assignment in
each Surround mode.
Surround
Mode
Tip: You can set the surround pan either independently of normal panpots or in unison with
them.
Setting Up and Selecting Surround Pan Modes
To configure the surround environment, select 3-1, 5.1, or 6.1 Surround mode on the
01V96 and connect a digital MTR or multi-channel monitoring system to the 01V96.
1 Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly until the
Pan/Route | Surr Mode page appears.
A
SURROUND MODE
This parameter enables you to select a Surround mode by using the following buttons.
The button that is turned on (highlighted) indicates the currently-selected Surround
mode.
• STEREO ........................ The 01V96 uses normal stereo mode (default).
• 3-1 .................................. Selects 3-1 Surround mode.
• 5.1................................... Selects 5.1 Surround mode.
• 6.1................................... Selects 6.1 Surround mode.
B
PAN/SURR LINK
When this button is turned on, Input Channel panpots and stereo surround panning are
linked.
C
Press this button to display the Surr/Bus Setup page, which enables you to change the
Surround Channel to Bus Out assignment.
01V96—Owner's Manual
BUS1
BUS2
L
R
3-1
Front left
Front right
L
R
5.1
Front left
Front right
L
R
6.1
Front left
Front right
1
BUS3
BUS4
BUS5
C
S
Center
Surround
Ls
Rs
Rear left
Rear right
Center
Ls
Rs
Rear left
Rear right
Center
BUS6
BUS7
—
—
—
C
LFE
—
Subwoofer
C
Bs
LFE
Rear center
Subwoofer
2
3