Yamaha MIXING CONSOLE Owner's Manual page 68

68
Chapter 5—Tutorial
Recording to the Master Recorder
Follow the steps below to record the mixed stereo signal from the 01V96 to the connected
master recorder.
1 Start recording on the master recorder, then start playing back on the digital
MTR.
During recording, observe the stereo meter on the right of the display and confirm that the
stereo output level is not clipping.
2 When the playback is finished, stop the master recorder, then stop the digital
MTR.
3 Turn on the [ON] button for ST IN Channel 2 in the ST IN section. The button
indicator lights up.
4 Play back the recording on the master recorder.
The playback signal is input at the 01V96's 2TR IN DIGITAL connector, then routed
through ST IN Channel 2 to the Stereo bus.
Note: Most consumer-type DAT recorders and MD recorders are unable to synchronize to
external wordclock during playback (that is, they cannot be wordclock slaves). If this type of
master recorder is connected to the 01V96's 2TR IN DIGITAL connector, access the DIO/Setup
| Word Clock page and select "2TRD" (2TR IN DIGITAL) as the wordclock source.
When the master recorder finishes playing back, turn off the [ON] button for ST IN Chan-
nel 2.
Tip: If you desire, you can store the current mix settings to memory as a Scene (see page 161).
01V96—Owner's Manual