Yamaha MIXING CONSOLE Owner's Manual page 268

268
Appendix A: Parameter Lists
REV->PAN
One input, two output reverb and autopan effects in parallel.
Parameter
REV TIME
INI. DLY
HI. RATIO
DIFF.
DENSITY
HPF
LPF
REV.BAL
FREQ.
DEPTH
DIR.
WAVE
SYNC
NOTE
1. L<–>R, L–>R, L<–R, Turn L, Turn R
2.
DELAY+ER.
One input, two output delay and early reflections effects in parallel.
Parameter
DELAY L
DELAY R
FB. DLY
FB. GAIN
HI. RATIO
HPF
LPF
DLY/ER
TYPE
ROOMSIZE
LIVENESS
INI. DLY
DIFF.
DENSITY
ER NUM.
SYNC
NOTE L
NOTE R
NOTE FB
1.
setting)
01V96—Owner's Manual
Range
0.3–99.0 s Reverb time
0.0–500.0 ms Initial delay before reverb begins
0.1–1.0 High-frequency reverb time ratio
0–10 Spread
0–100% Reverb density
THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
Reverb and panned reverb balance (0% = all panned reverb,
0–100%
100% = all reverb)
0.05–40.00 Hz Modulation speed
0–100% Modulation depth
1
Panning direction
Sine, Tri, Square Modulation waveform
OFF, ON Tempo parameter sync on/off
2
Used in conjunction with TEMPO to determine FREQ.
Range
0.0–1000.0 ms Left channel delay time
0.0–1000.0 ms Right channel delay time
0.0–1000.0 ms Feedback delay time
Feedback gain (plus values for normal-phase feedback,
–99 to +99%
minus values for reverse-phase feedback)
0.1–1.0 High-frequency feedback ratio
THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
Delay and early reflections balance (0% = all delay, 100% =
0–100%
all early reflections)
S-Hall, L-Hall, Random,
Type of early reflection simulation
Revers, Plate, Spring
0.1–20.0 Reflection spacing
0–10 Early reflections decay characteristics (0 = dead, 10 = live)
0.0–500.0 ms Initial delay before reverb begins
0–10 Spread
0–100% Reverb density
1–19 Number of early reflections
OFF, ON Tempo parameter sync on/off
Used in conjunction with TEMPO to determine left channel
1
DELAY L
Used in conjunction with TEMPO to determine right channel
1
DELAY R
Used in conjunction with TEMPO to determine FB. DLY
1
Description
Description
(Maximum value depends on the tempo