Bus Outs; About Stereo Out - Yamaha MIXING CONSOLE Owner's Manual

8 Bus Outs

This chapter describes how to adjust the 01V96's Stereo Out and Bus Out 1–8 parameters.

About Stereo Out

The Stereo Out section receives Input Channel and Bus Out 1–8 signals, mixes them into
two channels, processes them using on-board EQ, compressor, etc., then routes them to the
STEREO OUT and 2TR OUT connectors. The following diagram illustrates the Stereo Out
signal flow.
INSERT
• INSERT
This section enables you to route the Stereo Out signals to external devices via the on-board
connectors or I/O card, or insert internal effects processors.
• ATT (Attenuator)
This section enables you to attenuate or amplify the level of signals to be input to the EQ.
The attenuator prevents post-EQ signals from clipping or corrects signal levels that are too
low.
• 4 BAND EQ (4-band equalizer)
This parametric EQ features four bands (HIGH, HIGH-MID, LOW-MID, and LOW).
• COMP (Compressor)
This dynamics processor can be used as compressor, expander, or limiter. The processor can
be located pre-EQ, pre-[STEREO] fader, or post-[STEREO] fader.
• ON (On/Off)
This button turns the Stereo Out on or off.
• LEVEL
The [STEREO] fader adjusts the Stereo Out output levels.
• Balance
This section enables you to adjust the level balance between the L and R channels of the Ste-
reo Out.
• OUTPUT DELAY (Output delay)
This section delays the output signals. It is mainly used to fine-tune the signal timing.
(Gain Reduction) (Out Meter)
METER METER
COMP
INSERT
INSERT
METER
ON
LEVEL
4BAND
ATT
EQ
Same as stereo master L
METER
BAL
OUTPUT
DA
DELAY
DA
OUTPUT PATCH
97
Bus Outs
L
(-10dBV) [2TR OUT]
R
L
(+4dBu)
[STEREO OUT]
R
01V96—Owner's Manual
8