Yamaha MIXING CONSOLE Owner's Manual page 124

124
Chapter 10—Input & Output Patching
Changing the Signal Path to the ADAT OUT Connector, Slot,
or OMNI OUT connectors
Follow the steps below to change the signal path patched to the ADAT OUT connector, the
optional mini-YGDAI card installed in the slot, or the OMNI OUT connectors.
1 Press the DISPLAY ACCESS [PATCH] button repeatedly until the Patch | Out
Patch page appears.
Each parameter box displays the currently-patched signal path.
A
SLOT 1-16
These parameter boxes set the routing of Slot Channel 1-16 signals.
B
ADAT 1-8
These parameter boxes set the routing of ADAT OUT connector output channel 1-8 sig-
nals.
C
OMNI 1-4
These parameter boxes set the routing of OMNI OUT connector 1-4 signals.
The parameter indicators are explained below:
–
BUS1–BUS8
AUX1–AUX8
ST L/R
INS CH1–INS CH32
INS BUS1–INS BUS8
INS AUX1–INS AUX8
INS ST-L/ST-R
CAS BUS1–BUS8
CAS AUX1–AUX8
CAS ST-L/ST-R
CASSOLOL/CASSOLOR
2 Move the cursor to a patch parameter you wish to change, then rotate the
Parameter wheel or press the [INC]/[DEC] buttons to modify the patching.
3 Press [ENTER] to confirm the change.
Tip: You can store the Output Patch settings to the Output Patch library. Refer to Chapter 16
for more information.
01V96—Owner's Manual
1
2
3
Parameter value Description
No assignment
Bus Out 1–8 signal
Aux Out 1–8 signal
Stereo Out signal
Input Channel 1–32 Insert Out
Bus Out 1–8 Insert Out
Aux Out 1–8 Insert Out
Stereo Out Insert Out
Bus 1–8 Cascade Outs
Aux Bus 1–8 Cascade Outs
Stereo Bus Cascade Outs
Solo Bus Cascade Outs