Setting Up And Selecting Surround Pan Modes - Yamaha O1V96 Owner's Manual

136
Chapter 12—Surround Pan
• 6.1
This mode uses seven channels that include six
channels of 5.1 mode plus rear center.
When you select one of these Surround modes,
each surround channel signal is output as the Bus Out signal specified on the DIO/Setup |
Surr Bus page (see page 139).
The following table shows the factory-default Surround Channel to Bus Out assignment in
each Surround mode.
Surround
Mode
Tip: You can set the surround pan either independently of normal panpots or in unison with
them.

Setting Up and Selecting Surround Pan Modes

To configure the surround environment, select 3-1, 5.1, or 6.1 Surround mode on the
01V96 and connect a digital MTR or multi-channel monitoring system to the 01V96.
1 Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly until the
Pan/Route | Surr Mode page appears.
01V96 Version 2—Owner's Manual
BUS1 BUS2
L R
3-1
Front left Front right
L R
5.1
Front left Front right
L R
6.1
Front left Front right
1
Front L
Rear L
BUS3 BUS4 BUS5
C S
Center Surround
Ls Rs
Rear left Rear right Center
Ls Rs
Rear left Rear right Center
Subwoofer
Center Front R
Rear center Rear R
BUS6 BUS7
— — —
C LFE
—
Subwoofer
C Bs LFE
Rear center Subwoofer
2
3