Yamaha MIXING CONSOLE Owner's Manual page 265

REV+CHORUS
One input, two output reverb and chorus effects in parallel.
Parameter
REV TIME 0.3–99.0 s
INI. DLY 0.0–500.0 ms
HI. RATIO 0.1–1.0
DIFF. 0–10
DENSITY 0–100%
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
REV/CHO 0–100%
FREQ. 0.05–40.00 Hz
AM DEPTH 0–100%
PM DEPTH 0–100%
MOD. DLY 0.0–500.0 ms
WAVE Sine, Tri
SYNC OFF, ON
1
NOTE
1.
REV->CHORUS
One input, two output reverb and chorus effects in series.
Parameter
REV TIME 0.3–99.0 s
INI. DLY 0.0–500.0 ms
HI. RATIO 0.1–1.0
DIFF. 0–10
DENSITY 0–100%
HPF THRU, 21.2 Hz–8.00 kHz High-pass filter cutoff frequency
LPF 50.0 Hz–16.0 kHz, THRU Low-pass filter cutoff frequency
REV.BAL 0–100%
FREQ. 0.05–40.00 Hz
AM DEPTH 0–100%
PM DEPTH 0–100%
MOD. DLY 0.0–500.0 ms
WAVE Sine, Tri
SYNC OFF, ON
1
NOTE
1.
Range
Reverb time
Initial delay before reverb begins
High-frequency reverb time ratio
Spread
Reverb density
Reverb and chorus balance (0% = all reverb, 100% = all cho-
rus)
Modulation speed
Amplitude modulation depth
Pitch modulation depth
Modulation delay time
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
Range
Reverb time
Initial delay before reverb begins
High-frequency reverb time ratio
Spread
Reverb density
Reverb and chorused reverb balance (0% = all chorused
reverb, 100% = all reverb)
Modulation speed
Amplitude modulation depth
Pitch modulation depth
Modulation delay time
Modulation waveform
Tempo parameter sync on/off
Used in conjunction with TEMPO to determine FREQ.
Effects Parameters
Description
Description
01V96—Owner's Manual
265