Yamaha MIXING CONSOLE Owner's Manual page 126

126
Chapter 10—Input & Output Patching
• PRE EQ.......................... Immediately before Input Channel EQ
• PRE FADER .................. Immediately before Input Channel fader
• POST FADER ............... Immediately after Input Channel fader
2 Move the cursor to a patch parameter (1–32) you want to change, then
rotate the Parameter wheel or press the [INC]/[DEC] buttons to select the
destination.
If necessary, specify the signal source position using the DIRECT OUT parameter.
3 Press [ENTER] to confirm the change.
Note: If you select a destination that has already been used for an output patch, the patch
parameter box indicates "– (no assignment)." If you assign the Direct Out to an unused des-
tination, the parameter box indicates the corresponding output.
4 Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly until one of
the following pages containing the channels you want to patch to the Direct
Out appears.
• Rout1-16 page .............. This page enables you to change the Input Channel 1–16 rout-
• Rout17-STI page.......... This page enables you to change the Input Channels 17–32 and
Tip: Refer to page 86 for more information on these pages.
5 Move the cursor to the D button for the channel you want to patch to the
Direct Out, then press [ENTER].
The Direct Out patching is now effective, and the signals are routed to the assigned outputs,
ADAT OUT channels, or slot output channels.
01V96—Owner's Manual
ings.
ST IN Channel 1–4 routings.