Yamaha MIXING CONSOLE Owner's Manual page 89

• ON/OFF button ...........This button turns on or off the currently-selected Input Chan-
• Fader ..............................This parameter sets the fader position of the currently-selected
B
SURROUND PAN section
• SURROUND PAN........The Surround pan parameters for the currently-selected Input
C
BUS ROUTING/FOLLOW PAN section
• BUS ROUTING ............This section enables you to select a destination Bus for the
• FOLLOW PAN..............This button determines whether the Input Channel's Pan set-
D
AUX section
• AUX................................These controls set the currently-selected Input Channel's Aux
E
Meter section
• Meters............................These meters indicate the levels of the currently-selected Input
• PRE EQ/PRE FADER/POST FADER ...........The metering position is displayed below
F
GROUP section
• FADER/MUTE/EQ/COMP ............... These buttons indicate which Fader, Mute, EQ,
Setting the Input Channels from the Display
nel.
Input Channel. The fader knob is highlighted when the fader is
set to 0.0 dB.
Press the [ENTER] button to reset the Fader to 0.0 dB.
Channel are displayed only when a Surround mode is selected.
See page 135 for more information on Surround pan.
selected channel. When the D button is turned on, the channel
signal is patched to the Direct Out selected in the parameter
box below the button. (The D button is unavailable for the ST
IN Channels.)
ting is applied to the paired Bus Outs (Follow Pan function).
When the button is turned off, the Follow Pan function is dis-
abled and an identical signal is sent to the paired Bus Outs.
Send 1–8 levels and positions. (See page 109 for more informa-
tion on Aux Sends.)
Channel.
the meters.
or Comp group, if any, the currently-selected
Input Channel is in. If the channel is in a group,
the group number appears. If the channel is not
in a group, "—" appears. (The compressor is
unavailable for the ST IN Channels.)
89
01V96—Owner's Manual
7