Input Channels; About Input Channels - Yamaha MIXING CONSOLE Owner's Manual

7 Input Channels

This chapter describes how to adjust the 01V96's Input Channel parameters.

About Input Channels

The input Channel section enables you to adjust the level and tone of the signals input to
the 01V96 (and the signals output from the internal Effects processors 1–4), and route the
signals to Buses 1–8, the Stereo Bus, and Aux Sends 1–8. There are two types of Input Chan-
nels, each featuring slightly different functions: monaural Input Channels 1–32 and stereo
ST IN Channels 1–4.
Input Channels
Each of these monaural Input Channels features a phase effect, gate, compressor, attenua-
tor, and EQ for signal processing. The following diagram illustrates the Input Channel 1–32
signal flow.
INPUT 1(...32)
(Gain Reduction)
METER
GATE
Keyin
12ch Group(1-12,13-24....)
AUX 1-8
Input Channels 1–32 feature the following parameters:
• (Phase)
This section switches the phase of input signals.
• GATE
This dynamics processor can be used as a gate or for ducking.
• COMP (Compressor)
This dynamics processor can be used as compressor, expander or limiter. The compressor
can be pre-EQ, pre-fader, or post-fader.
• ATT (Attenuator)
This section enables you to attenuate or amplify the level of signals that will be input to the
EQ. The attenuator enables you to prevent post-EQ signals from clipping and to correct sig-
nal levels that are too low.
• 4 BAND EQ (4-band equalizer)
This parametric EQ features four bands (high, high-mid, low-mid, and low).
• INPUT DELAY (Input delay)
This section enables you to delay input signals. You can use this delay to fine-tune the timing
between channels, or as a delay effect with feedback.
1–32
(Out Meter)
METER
METER
INSERT
4BAND INPUT
ATT
EQ DELAY
(Gain Reduction) (Out Meter)
METER METER
COMP
Keyin
Self or Stereo Link
Input Channels
METER
SOLO
INSERT
ON LEVEL
PAN
PAN
LFE
PRE/POST ON AUX
DIRECT OUT 1(...32)
77
01V96—Owner's Manual
7