Attenuating Output Signals - Yamaha 006IPTO-F0 Owner's Manual

90
Chapter 7—Bus Outs

Attenuating Output Signals

To attenuate the DM1000's output signals, display the EQ | Out Att page and adjust the Ste-
reo Out and Bus Out 1–8 attenuators individually.
If necessary, you can also select Output and I/O card channels and specify the amount of
attenuation. This technique is convenient when you want to attenuate output signals
quickly, regardless of the source signal patching.
1 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup | Out-
put Att page appears.
2 Move the cursor in the left column (
the Parameter wheel to select the desired output or slot channel for which
you want to adjust attenuation.
The following outputs and slot channels can be selected:
• OMNI OUT 1–12.....................OMNI OUT connectors 1–12
• SLOT 1-1 through 1-16...........Channels 1–16 of Slot 1
• SLOT 2-1 through 2-16...........Channels 1–16 of Slot 2
3 Move the cursor to the parameter value in the right column (
the Parameter wheel or press the [INC]/[DEC] buttons to set the amount of
attenuation.
The amount of attenuation can be set from 0 dB to –9 dB.
Tip: To reset the attenuation amount of all Output Channels to 0 dB, move the cursor to the
INITIALIZE button, then press [ENTER].
DM1000 Version 2—Owner's Manual
1
1
), then scroll the list up or down using
2
2
), then rotate