Compressing Input Channels - Yamaha 006IPTO-F0 Owner's Manual

66
Chapter 6—Input Channels

Compressing Input Channels

To set the Input Channel compressors, use the [SEL] buttons to select the desired Input
Channel, then press the DISPLAY ACCESS [DYNAMICS] button, then the [F3] button to
display the Dynamics | Comp Edit page.
A
POSITION
Use the Parameter wheel, or the [INC]/[DEC] buttons to select the position of the com-
pressor within the channel from the following options:
• PRE EQ.......................... Immediately before EQ (default)
• PRE FADER .................. Immediately before the fader
• POST FADER ............... Immediately after the fader
B
STEREO LINK
This ON/OFF button enables you to pair compressors for stereo operation even when
channels are not paired.
C
CURVE
This area displays the current compressor curve.
D
TYPE
This field indicates the compressor type used by the currently-selected channel's com-
pressor (COMP/EXPAND/COMP (H)/COMP (S)).
E
Meters
These meters indicate the levels of the post-compressor signals and the amount of gain
reduction.
F
ON/OFF
The ON/OFF button turns the currently-selected Input Channel's compressor on or off.
G
PARAMETER section
These controls enable you to set the compressor parameters. (See page 325 for more
information on the parameters of each compressor type.)
DM1000 Version 2—Owner's Manual
1
6
Note: You cannot change the compressor type on this page. To change the compressor type,
recall a program that uses the desired compressor type from the compressor library.
Tip: You can store the compressor settings in the Compressor library, which features preset
programs that can be used for various applications (see page 183).
2 3
4
5
7