Table of Contents
Advertisement
5 Analog I/O & Digital I/O
This chapter describes the DM1000's analog and digital input/output connectors as well as
the basic operations involving the digital I/Os.
Analog Inputs & Outputs
AD Input Section
The DM1000's rear panel features Input connectors 1–16, which enable you to connect
microphone and line-level sources, and OMNI IN connectors, which enable you to connect
line-level sources. Signals input at these connectors can be patched to Input Channels. (See
page 109 for more information on patching Input Channels.)
• INPUT connectors 1–16
9
INPUT
• OMNI IN connectors 1–4
OMNI
3
• Phantom Power
• PAD switches
PAD
• GAIN controls
• PEAK & SIGNAL Indicators
These balanced XLR-3-31-type connectors accept line-level and
microphone signals. The nominal input range is –60 dB through
+4 dB.
8
These balanced XLR-3-31-type connectors accept line-level signals.
2
IN
The nominal signal level is +4 dB.
Inputs 1 through 16 feature switchable +48V phantom powering for
use with condenser-type microphones and direct boxes. Individual
1
+48V [ON/OFF] switches on each input turn phantom power on
+48V
and off.
OFF
ON
Inputs 1 through 16 feature pad switches, which attenuate input sig-
1
nals by 20 dB.
20dB
Inputs 1 through 16 feature rotary gain controls that adjust input
sensitivity. Input sensitivity ranges from +4 dB to –40 dB when the
Pad is on, and from –16 dB to –60 dB when the Pad is off.
-16
-60
GAIN
The SIGNAL indicator lights up when the input signal level is 20 dB
PEAK
below nominal. The PEAK indicator lights up when the input signal
SIGNAL
level is 3 dB below clipping.
Analog I/O & Digital I/O
DM1000 Version 2—Owner's Manual
53
5
Advertisement
Table of Contents
