Table of Contents
Advertisement
New Functions in DM1000 Version 2
The following functions have been added to the DM1000 as part of the upgrade of the firm-
ware from version 1.0 to version 2.0.
Control Surface
•
Encoder mode now features an assignable function, ALT LAYER, which enables you to con-
trol the channel level for all 32 channels without switching between layers. → page 36
There are now 50 assignable Encoder mode parameters. → page 38
•
Aux Sends
•
If an Aux Send is set to pre-fader, you can set the Pre point before or after channel mute.
→ page 99
•
The AUX SELECT [AUX 1–8] buttons enable you to solo or unsolo Aux Sends without
switching to the Master layer. → page 107
Control Room Monitor
•
You can select whether the Input Channel's Pan setting is used when the Input Channel Solo
signal is set to Pre Fader. → page 120
•
Raising the channel faders for soloed Channels from –∞ can unsolo the Channels.
→ page 121
•
You can simultaneously select 2TR D1 or 2TR D2, and STEREO as control room monitor
sources. → page 123
Surround Function
•
The on/off status of the Follow Pan button is reflected in the pan and Surround Pan
settings. → page 125
The Surround Monitor function now supports THX Surround. → page 138
•
You can simultaneously select BUS and SLOT as surround monitor sources. → page 137
•
Group/Link
•
The Fader Group Master function enables you to control the overall level of the Fader group
channels simultaneously while maintaining the relative level balance of each channel.
→ page 150
•
The Mute Group Master function enables you to mute all channels in a Mute group
simultaneously. → page 152
Internal Effects
You can add optional Add-On Effects to the preset effects. → page 161
•
Scene Memory
•
Any channel or parameter settings in the current scene can be copied and pasted into other
scenes. → page 171
You can select additional parameters for the Recall Safe function. → page 170
•
New Functions in DM1000 Version 2
DM1000 Version 2—Owner's Manual
7
Advertisement
Table of Contents
