Yamaha 006IPTO-F0 Owner's Manual page 225

■ USER DEFINED KEYS section
• [1]–[12] buttons
You can assign one of 164 parameters to each of these buttons. In particular, if you assign
any of 53 Remote Control parameters to these buttons, you can operate the transport sec-
tion and select various Pro Tools modes from the DM1000 top panel. See page 274 for more
information on assigning the parameters to the buttons.
Parameter
Places Pro Tools in Record Enabled mode. The button indicator flashes while
DAW REC
the transport section is stopped. The indicator lights up when recording starts.
DAW PLAY
Starts playback from the current cursor position.
DAW STOP
Stops playback and recording.
DAW FF
Fast forwards the cursor position.
DAW REW
Fast rewinds the cursor position.
DAW SHUTTLE
Switches Wheel mode to Shuttle.
DAW SCRUB
Switches Wheel mode to Scrub (Jog).
You can audition the pre-roll, post-roll, in-point area, or out-point area by
DAW AUDITION
holding down the button to which this function is assigned and pressing a
button to which DAW PRE, DAW POST, DAW IN, or DAW OUT is assigned.
DAW PRE
Plays back from the pre-roll point up to the beginning of the selected area.
Plays back from the beginning of the selected area for a duration specified as
DAW IN
the pre-roll.
Plays back to the end of the selected area for a duration specified as the
DAW OUT
post-roll.
Plays back from the end of the selected area for a duration specified as the
DAW POST
post-roll.
DAW RTZ
Moves the playback cursor to the beginning of the session.
DAW END
Moves the playback cursor to the end of the session.
DAW ONLINE
Toggles between on-line and off-line.
DAW LOOP
Toggles between Loop Playback on and off.
DAW QUICKPUNCH
Toggles between QuickPunch on and off.
DAW AUTO FADER
DAW AUTO MUTE
DAW AUTO PAN
Correspond to the Automation Overwrite (Auto Enable) functions.
DAW AUTO SEND
DAW AUTO PLUGIN
DAW AUTO SENDMUTE
DAW AUTO READ
DAW AUTO TOUCH
DAW AUTO LATCH
Select Automation modes.
DAW AUTO WRITE
DAW AUTO TRIM
DAW AUTO OFF
Cancels Automation recording and playback for all channels. When Automa-
DAW AUTO SUSPEND
tion is interrupted, the LED flashes, and channel strip controls maintain the
current settings.
Displays the channel Automation mode (Read, Tch, Ltch, Wrt, or Off). The
mode setting appears at the bottom of each channel on a Channel or Meter
DAW AUTO STATUS
Display page when you press and hold the button to which this function is
assigned.
Displays a Group ID (to which each channel belongs) below each channel
DAW GROUP STATUS
number on a Channel or Meter Display page (in all caps for a main group and
in lowercase letters for a sub-group).
Pro Tools Remote Layer
Function
DM1000 Version 2—Owner's Manual
225
17