Assigning Scenes To Program Changes For Remote Recall - Yamaha 006IPTO-F0 Owner's Manual

• Tx ON/OFF...................Transmission of Parameter Change messages is enabled or dis-
• Rx ON/OFF ................... Reception of Parameter Change messages is enabled or disabled.
• ECHO ON/OFF............This button determines whether Parameter Change messages
E
BULK
This parameter row enables or disables reception of Bulk Dump data.
• Rx ON/OFF...................Reception of Bulk Dump data is enabled or disabled.
F
OTHER COMMANDS
• ECHO ON/OFF............This button determines whether other MIDI messages received
G
Fader Resolution
This parameter specifies the resolution of the value output when you operate the
DM1000's faders. To transfer fader value data between two cascaded DM1000s, or to
record the DM1000 operation to or play it back from a sequencer, select the HIGH but-
ton. When the LOW button is selected, the fader resolution switches to 256 steps.

Assigning Scenes to Program Changes for Remote Recall

You can assign DM1000 Scenes to MIDI Program Changes for remote recall. When you
recall a Scene on the DM1000, the unit transmits the assigned Program Change to the con-
nected MIDI device. When the DM1000 receives a Program Change, the assigned Scene is
recalled.
Initially, Scenes 1 through 99 are assigned sequentially to Program Changes 1 through 99,
and Scene #0 is assigned to Program Change #100, although you can change these assign-
ments.
Tip: You can store a Scene to Program Change assignment table to an external device by using
MIDI Bulk Dump or included Studio Manager software.
1 Press the DISPLAY ACCESS [SETUP] button repeatedly until the Setup |
MIDI/Host page appears, then specify ports for transmission and reception
of MIDI messages (see page 246).
2 Make connections using the ports selected in Step 1 so that the DM1000 can
transfer MIDI messages to and from the external device.
3 Press the DISPLAY ACCESS [MIDI] button, then press the [F2] button.
The MIDI | Pgm Asgn page appears.
Assigning Scenes to Program Changes for Remote Recall
abled.
received at the MIDI IN port are echoed through to the MIDI
OUT port.
at the MIDI IN port are echoed through to the MIDI OUT
port.
249
DM1000 Version 2—Owner's Manual
18