Network - Dahua Technology DHI-ITC952-RF2D User Manual

6.5.2.2.3 Interest Area
Step 1 Select Setting > Camera > Video > Interest Area.
The Interest Area interface is displayed. See Figure 6-88.
Step 2 Drag the mouse in the video image to configure the interest area. It is shown in a yellow
box.
Step 3 Configure the parameters. See Table 6-29.
Parameter
Image Quality
Remove All
Delete
Step 4 Click OK to save the configuration. Click Refresh to refresh the interface. Click Default
and then OK to restore to default settings.

6.5.3 Network

You can configure network parameters such as IP address, MAC address, subnet mask, default
gateway, etc.
6.5.3.1 TCP/IP
You can configure host name, IP address, etc.
Step 1 Select Setting > Network > TCP/IP.
The TCP/IP interface is displayed. See Figure 6-89.
Some models are designed with two network ports. Do not configure the ports in the same
network segment; otherwise, the network may fail.
Figure 6-88
Table 6-29 Parameters of interest area
Description
6 quality levels are available. The higher the value, the better the quality.
Click to delete all the interest areas.
Click to delete the most recently configured interest area. You can click
several times to delete more than one area. You can also right-click on the
video image to delete interest area.
Interest area
Web Configuration 79