Dahua Technology DHI-ITC952-RF2D User Manual page 73

Parameter
Frequency
Lamp
6.5.1.8.3 Power Config
The Camera can ouput DC12V power when the power switch is on.
Step 1 Select Setting > ITC > Extra Device > Power Config, the Power Config interface is
displayed. See Figure 6-71.
Step 2 Check Switch On, and the camera can supply DC12V power.
Step 3 Click OK to save the configuration. Click Refresh to refresh the interface. Click Default
and then OK to restore to default settings.
6.5.1.8.4 Anti-fog Function
You can enable anti-fog function if there is any droplet that may condense on the surface of
glasses and influence the quality of captured images.
Description
Configure the pulse width of flash lamp. The higher the value, the
Pulse Width
brighter the light.
Configure the delay time of the light to keep the snapshot in sync
Delay Time
with the flash.
You can select the level that activates the flashing light. Currently,
Burst Mode
only Low level is supported.
Forbidden: The light is normally off.

Always: The light is normally on.

Output
Default: Configure the Prevalue of brightness. When the

Mode
actual brightness is lower than this value, the light automatically
turns on.
Configure the delay time of the light to keep the snapshot in sync
Delay Time
with the flash.
Configure the pulse width of the light. The higher the value, the
Pulse Width
brighter the light.
Configure the flash frequency of the light. The higher the value,
Freq
the more frequent the light flashes.
Prevalue of brightness. You can drag the slider to adjust the
Prevalue
value. The higher the value, the brighter the light.
Figure 6-71 Power config
Web Configuration 66