Table of Contents
Advertisement
6.5.3.3 Auto Register
Step 1
Select Setting > Network > Auto Register. The Auto Register interface is displayed.
See Figure 6-91.
Step 2
Check Enable, and then the camera will automatically report its location to the server
designated by user when it is connected to network. This helps client software to
access the camera through the server for checking live video and monitoring.
Step 3
Configure the parameters. See Table 6-31.
Parameter
Enable
Server IP
Port
Sub-Device
ID
Step 4
Click OK to save the configuration. Click Refresh to refresh the interface.
6.5.4 Remote Device
The remote device can help the Device recognize signal lights when IR is selected as ICR
Switch from Setting > Camera > Attributes > General.
You can enable remote device and configure its parameters.
This function is available only in E-Police mode.
Step 1
Select Setting > Remote Device > remote Config.
The remote Config interface is displayed. See Figure 6-92.
Figure 6-90
Figure 6-91
Table 6-31 Auto register parameters
Description
Check to enable auto register.
The IP address of server that needs to be registered.
The port for auto register.
ID designated by the server for auto register device.
Make sure there is no same device ID.
Onvif user
Auto register
Web Configuration 81
Hide quick links:
Advertisement
Table of Contents
