Plate-Pixel Check - Dahua Technology DHI-ITC952-RF2D User Manual

Operation Description
PTZ
Setup
Preset
Config

6.2.3 Plate-pixel Check

You can check whether the Camera is properly zoomed and focused by capturing vehicle plate
and analyzing plate width pixel.
Step 1 Click Next after configuring PTZ, or click Plate-pixel check.
The Plate-pixel check interface is displayed. See Figure 6-15.
Click Back and you can return to configure the PTZ.

Preset: Enter in
configure 6 preset points at most.

Daytime: Click the drop-down list to select the work mode of corresponding
preset point. You can select Daytime, Night, Dawn/Dusk, and Other.
You cannot configure the same work mode for different present points.

Reset: Click Reset, and the PTZ will restore to the state when it is not
zoomed and focused.

Go to: Click Go to, and it will go to the preset point you set in
.

: Click this icon to add a preset point.

: Click this icon to delete a preset point.
You can view and change the settings in PTZ setup. See Figure 6-14.

Go to: Click Go to, and it will go to the corresponding preset point.

OK: Select the work mode you want to change, and click OK. The system
prompts Operate Succeeded!

Del: Click it to delete the corresponding preset point.
to configure the preset point. You can
Web Configuration 25