Table of Contents
Advertisement
Step 2
Check start Remote Device, and configure the parameters, including name, IP
address, user name and password of the remote device.
Step 3
Click OK to save the configuration. Click Refresh to refresh the interface.
Linkage snapshot is enabled by default. The Event Type and the Snap Amount are
also set by default.
6.5.5 Event
It is to configure alarm and abnormality.
6.5.5.1 Alarm
6.5.5.1.1 Relay Activation
You can connect the alarm output device to corresponding I/O port.
Step 1
Select Setting > Event > Alarm> Relay Activation.
The Relay Activation interface is displayed. See Figure 6-93.
Step 2
Check Enable.
Step 3
Configure the parameters. See Table 6-32.
Parameter
Relay-in
Period
Figure 6-92
Figure 6-93
Table 6-32 Relay activation parameters
Description
Current, only 4 channels support alarm input.
Configure the time of arming and disarming.
Remote config
Relay activation
Web Configuration 82
Hide quick links:
Advertisement
Table of Contents
