Lamp Config; Lane Property - Dahua Technology DHI-ITC952-RF2D User Manual

6.2.5 Lamp Config

The Camera is designed with 7 ports that can be connected to different types of lights. You can
select the type of light connected to each port.
Step 1 Click Next after configuring Trigger Mode, or click Lamp Config.
The Lamp Config interface is displayed. See Figure 6-27.
Step 2 Select the type of light connected to each port.
Step 3 Click Test to test whether the light is successfully connected.
After clicking Test, check whether the light is successfully connected in the video image
at the right side.
Step 4 Click OK to save the configuration. Click Refresh to refresh the interface.
Step 5 Click Next to configure the Lane Property.
Click Back and you can return to configure the Trigger Mode.

6.2.6 Lane Property

You can configure the event type of each lane. Different work modes (ANPR and E-Police)
support different event types, and the actual product shall prevail.
Step 1 Click Next after configuring Lamp Config, or click Lane Property.
The Lane Property interface is displayed. See Figure 6-28 and Figure 6-29.
Figure 6-27 Lamp Config
Web Configuration 33