Table of Contents
Advertisement
Select Protocol (start an infusion)
Under normal, everyday circumstances most users of dedicated infusion pumps
use the pumps to perform the same or limited number of infusion protocols for the
majority of patients. For example, in pain management it is common for patients to
be on a morphine regime consisting of bolus only delivery of a concentration of 1-
2mg/ml morphine supplied by pharmacy in a fixed infusion bag volume. The
service may use different bolus volumes or lockout times depending on individual
patient needs.
This means once you have set up these protocols, using the Level 2 Access Code
in 'Modify Program' as described in the previous section, Level 1 code users can
access the pump and run the standard protocols for a patient without having to
enter or change any infusion parameters.
This is achieved as follows: -
1.
Load the administration set as explained
previously. Turn the pump on by pressing
. The following will appear.
2.
If the previous infusion was not over, the
following screen will appear:
3.
To continue previous infusion, press
review the selected protocol details and press
until the pump prompts to "Start new
infusion?".
infusion.
4.
To start a new infusion press
code. Enter relevant and press
Software ver. CVPCA30E_1
Confirm
with
33
,
and
start
. The screen than will prompt for
.
Hide quick links:
Advertisement
Table of Contents
