Select Protocol (Start An Infusion) - CME BodyGuard 595 Color Vision Operator's Manual

44. If the protocol parameters that were set exceed
the toxicity limit (MediGuard
not allow you to proceed to the next step and will
alarm "MediGuard
to the "Max MediGuard
can check and amend your entry.
45. Finally confirm protocol parameters by pressing
and going back to main menu,
Or pressing
parameters.

NOTE: BodyGuard 595 Color Vision™ is capable of delivering the bolus dose at
up to 1200 ml/hr. The user can adjust bolus delivery down to a minimum of 40
ml/hr in "Change set up mode" using the level three access code.

Select Protocol (start an infusion)

Under normal, everyday circumstances most users of dedicated infusion pumps use the
pumps to perform the same or limited number of infusion protocols for the majority of
patients. For example, in pain management it is common for patients to be on a
morphine regime consisting of bolus only delivery of a concentration of 1-2mg/ml
morphine supplied by pharmacy in a fixed infusion bag volume. The service may use
different bolus volumes or lockout times depending on individual patient needs.
This means once you have set up these protocols, using the level three access code in
'Modify Protocol Library' as described in the previous section, Level 1 code users can
access the pump and run the standard protocols for a patient without having to enter or
change any infusion parameters.
This is achieved as follows:
1. Load the
previously. Turn the pump on by pressing
The following will appear.
BodyGuard 595™Color Vision Operator Manual
TM
level) the pump will
TM
Limit Exceeded" and return
TM
Rate" screen so you
to review and change
administration set
PCA
MEDIGUARD LIMIT
EXCEEDED
PCA
A: MORPHINE
Confirm: Press
Review: Press
as explained
BodyGuard 595
.
Color Vision Pain Manager
Pump Serial Number:
Production Date:
Software Version
BGCV595_01L
Protocol
4 – Operation
10:00 - 70%
10:00 - 70%
V123456
1-Jan-2000
Sample
█
■
█
■
43