GE VersaMax IC200PWR001 User Manual page 52

Installing and Removing a Prewired Cable
To install a prewired connecting cable, place the cable connector over the
connector on the carrier and press downward until the latch engages the tab on
the connector.
To remove the cable, hold the cable connector and press up on the latch to
release the connector. When removing the cable, remember that operating
equipment may be very hot, especially at higher ambient temperatures. If the
equipment is hot, do not touch it directly.
DO NOT TOUCH exposed connector pins if the system is operating.
Connector Kit
A connector kit (part number IC200ACC304) is available for building custom
cables or for connecting wires directly from field devices. The kit includes two
connectors and covers, four screws, 27 small contacts, and 12 large contacts.
The following equipment is also required but not included in the kit:
Crimping Tools
Extraction Tools
Terminal Numbering
The following illustration displays the terminal assignments of the connector
pins as viewed from above.
A terminals
A1 A2
A17
A6
A18
A11 A12
GFK-1504N Chapter 2 Installation
small contact
large contact
small contact
large contact
B terminals
A3 A4 A5 B5 B6 B3 B4 B1 B2
A7 A8 A9 A10 B12 B9 B10 B7 B8
A13 A14 A15 A16 B15 B16 B13 B14 B11
Cable
Cable
Latch
Molex 11-01-0008
Molex 11-01-0084
Molex 11-03-0002
Molex 11-03-0006
B17
B18
2
2-25