GE VersaMax IC200PWR001 User Manual page 238

8
IC200MDL742
Output Module, 24 V DC Positive Logic 0.5 A, w/ESCP 32 Points
Module Specifications
Module Characteristics
Points
Module ID
Isolation:
User input to logic (optical) and to
frame ground
Group to group
Point to point
LED indicators
Backplane current consumption
External power supply
Thermal derating
Compatibility
HW,FW vers.
FW release
Output Characteristics
Output voltage
Output voltage drop
Load current
Steady-state overcurrent trip point
Output leakage current
On and Off response time
Protection (each output)
External Power Supply Requirements
The external power supply used to power the loads must provide sufficient field
power for the module during short circuit events. When a load is shorted, an
inadequate external power supply may allow field power to drop below the specified
operating range, causing misoperation of the module. The external power supply
must be capable of providing short circuit energy without degradation of output
voltage levels. The amount of energy required depends on the number of
simultaneously-shorted points that might occur. Refer to power supply short circuit
operation specifications when selecting the power supply to be used with the loads.
Local energy storage (either batteries or capacitors) can be used to compensate for
insufficient power supply characteristics. Additional best practices including
minimizing wiring resistance from the external power supply to the module must be
observed.
8-28 VersaMax Modules, Power Supplies and Carriers User's Manual
2 groups of 16 outputs
80808080
250 V AC continuous; 1500 V AC for 1 minute
250 V AC continuous; 1500 V AC for 1 minute
None
One green LED per point shows individual point on/off state
One amber LED per point shows individual point overloads
FLD PWR LED indicates field power is present
OK LED indicates backplane power is present
5 V output: 150mA maximum
+18 to +30 V DC, +24 V DC nominal
Refer to associated diagram
Cimplicity Versa Control
ME Pro 90
2.11 1.1 2.4
+18 to +30 V DC, +24 V DC nominal
0.5 V maximum
0.5A at 30 V DC maximum (resistive)
2.0A inrush maximum for 100ms
1.6A typ., 0.7A to 2.5A max range
0.5mA at 30 V DC maximum
0.5ms, maximum
Short circuit and overcurrent protection, free-wheeling diodes
CPU CPU CPU CPU
001 002 005 E05
AA AA AA AA
1.0 1.5 2.1 2.1
DBI EBI GBI PBI
001 001 001 001
AA AA AA AA
1.1 1.0 1.0 1.0
GFK-1504N