Table of Contents
Advertisement
Driver Installation
Before direct printing, direct scanning or using ControlCentre through the Parallel Port or the
USB port, you will need to install a driver.
The procedure will install the driver and configure it for the local port.
To install the driver on the workstation.
Insert the Driver CD into the CD drive.
1
Within a few seconds, the CD should start automatically and present you with the opening
screen. If this does not happen, go to the Start menu, select [Run] and browse to the CD
drive. Select [Setup] and click [OK]. Click [OK] to start the installation procedure.
2
Select the language for the installation and select [Continue].
The driver screen is displayed.
3
Check the boxes for the drivers required, PostScript, PCL, PC Scan and ControlCentre.
Select [Continue].
Page 2-24
You can choose to install as many drivers as you require by checking the appropriate boxes.
Xerox CopyCentre C20, WorkCentre M20 and WorkCentre M20i User Guide
Advertisement
Table of Contents
