Before You Start - Xerox 480 ST System Administration Manual

Before You Start

NOTE
Xerox Document Centre System Administration Guide
Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot.
Your printer and your network accounting solution software or
server must be connected to a network which has the TCP/IP
protocol enabled and all TCP/IP information such as hostname,
Default Gateway and Broadcast address have been set.
Your Document Centre and network accounting solution server
should be assigned TCP/IP addresses and the HTTP protocol must
have been enabled at your Document Centre. If necessary, refer to
the Internet Services Quick Install Card to configure your
Document Centre in this manner.
If Dynamic TCP/IP addressing must be used, be sure to set lease
times long enough to allow for normal maintenenace shutdowns. If
your Document Centre appears to have stopped communicating
with the network accounting solution when Dynamic Addressing is
in use, check the TCP/IP settings to be sure they have not changed.
As a quick test to verify all the requirements have been met, start the
Web Browser from your network accounting solution server and
enter the IP address of the Document Centre to see if you can
communicate with it using the HTTP protocol. If the Browser
connects and you can see the "Home Page" proceed to the next
section entitled Go to the Document Centre and...
Page 18 - 3