Microsoft (Netbeui) Networks B5; Before You Start; Enabling The Smb Setting At The Device, If Required - Xerox WorkCentre 7228 System Administrator Manual

Microsoft (NetBEUI) Networks

Before You Start

1. Print a Settings List as stated in the Network Connectivity section of this guide.
2. On the Settings List, verify that SMB is enabled. Also, verify that the default name of the NetBEUI
workgroup is "Workgroup" and that the Device has a unique name (that is, a name not the same as
any other device in your workgroup). To enable SMB, if required, follow the procedure below. To
modify the name of your Workgroup, or Device's name within your workgroup, use your workstation's
Web browser to access the Internet Services (Web Pages) residing in the Device as described below.

Enabling the SMB Setting at the Device, if required

1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press the rectangular Confirm button on the touch screen.
4. Press the System Settings button (the right-hand button of the two buttons displayed on the touch
screen). Note: If you press the left button by mistake, the Main menu will be displayed and you will
have to start over at step one above.
5. Press the System Settings button.
6. Press the Network Settings button.
7. Press the Port Settings button to access the Port Settings menu.
8. When the Port Settings menu displays, press the SMB selection line.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
B5
38