Go To A Workstation And - Xerox 480 ST System Administration Manual

Go to a workstation and...

NOTE
Xerox Document Centre System Administration Guide
This procedure assumes that any TCP/IP components necessary for
network installation have already been assigned to the Document
Centre. If these components have not been configured, please refer
to the appropriate information contained within the section entitled
Dynamic/Static IP Addresses & WINS before continuing further.
1. Mount the CentreWare Network Services CD-ROM .
Solaris/SunOS, HP-UX, and AIX users can load the
CentreWare Print DCPR Tool. Details are contained in the
document entitled CentreWare Network Services Guide.
2. Add the printers host name, TCP/IP address, hardware
address to your /etc/hosts file or NIS database depending on
your UNIX version.
3. Create a queue using the CentreWare tool OR by using the
native tools available in your operating system version.
4. Create a print job and send it to the printer.
5. Check your test job for quality and use the Problem Solving
section of the Document Centre Reference Guide for
resolving print defects.
6. If your print job does not print, refer to the Troubleshooting
section in this document entitled TCP/IP Troubleshooting
to correct the problem.
7. Repeat this Go to a workstation and... procedure at each
workstation that will print to this printer.
Page 7 - 3