Novell Netware 3.1X Or 4.X/5.X In Bindery Mode; Before You Start - Xerox 480 ST System Administration Manual

6. Novell NetWare 3.1x or 4.x/5.x in
Bindery Mode

Before you start

Xerox Document Centre System Administration Guide
To enable 100BaseT or a Token Ring interface, refer to
Chapter 2 How to Connect to Ethernet or Token Ring
Networks section to configure the Ring Speed and
Source Routing settings for your environment.
The CentreWare software supplied with your printer can
be used to set up your printer on your Novell network.
For details refer to the document entitled CentreWare
Network Services Guide. This procedure assumes you
ran PCONSOLE to set up a print server. Please refer to
the documentation supplied by Novell to complete this
task. Record precisely (observe upper and lower case,
punctuation etc.) the following: the Primary Server
name, Frame type used, Print Server name, Print
Server password, and the Queue name assigned.
Page 6 - 1