Go To A Workstation And - Xerox 480 ST System Administration Manual

Page 22 - 6

Go to a workstation and...

1. Create a test job and send it to the printer with a workstation
utility, or through a queue on your operating system that sup-
ports Port 9100 printing.
2. Check your test job for quality and use the problem solving
section of the Document Centre Reference Guide for
resolving print defects.
3. If your print job does not print, refer to the troubleshooting
section in this document entitled TCP/IP Troubleshooting
to correct the problem.
4. Repeat this Go to a workstation and... procedure at each
workstation that will print to this printer, or at other servers
where the queue was created.
Xerox Document Centre System Administration Guide