Unix Networks; Before You Start - Xerox 480 ST System Administration Manual

7. UNIX Networks

Before You Start

NOTE
Xerox Document Centre System Administration Guide
To enable 100BaseT or a Token Ring interface, refer to Chapter 2
How to Connect to Ethernet or Token Ring Networks to
configure the Ring Speed and Source Routing settings for your
environment.
Your Document Centre now has DHCP, LPR, and NetBIOS over
the IP protocol enabled by default. If your DHCP server will
provide host name, IP address, Gateway address, and Subnet Mask,
the Document Centre TCP/IP information will be configured on
initial boot. This means that if you have configured your DHCP
server with the desired information, you may go right to the area
within this section entitled Go to a Workstation and....
For information on how your printer can connect to a BOOTP
server, or a RARP server to be assigned an IP address dynamically,
refer to the section in this document entitled Dynamic/Static IP
Addresses & WINS. Information in regards to static IP address
configuration may be found within that section as well.
Your Document Centre printer supports printing from a variety of
UNIX platforms. The procedure contained in this document will
enable you to connect your printer in many of these environments.
Page 7 - 1