User Diagnostics; Emergency Shutdown; Unusual Or Erratic Operation; Troubleshooting For Operators - Xantrex XPR 10-600 Operating Manual

User Diagnostics

If your power supply is not performing as described in this manual, run through the
procedures and checks in this section before calling your service technician. These
procedures are confined to operator level functions only and do not require cover-off
servicing.
Emergency In an emergency, carry out both of these steps:
Shutdown
1. Shut the power supply OFF immediately.
2. Disconnect the power supply from the load.
Unusual or If the power supply displays any unusual or erratic operation, follow these steps:
Erratic
1. Shut the power supply OFF immediately.
Operation
2. Disconnect the power supply from the load.
3. Test the power supply with no load, running the tests in
4. If the tests show that the power supply is functioning normally, check all load,
5. Check the AC input for correct voltage and frequency.
If the problem is not solved after following this procedure, or if the unit fails to
operate correctly upon retesting, call your service technician.
Turn to the next page for more information about troubleshooting for operators.
Use the checks in
Troubleshooting
connected for normal operation. If you need any further troubleshooting, call your
for Operators
service technician.
Abbreviated References Used in Table
AC
OTP
OVP
INT
RMT Remote Mode
Release 1.1
programming, and monitoring connections and circuits.
Table 3.3
AC Fail
Over Temperature Protection
Over Voltage Protection
Interlock
to ensure that the power supply is configured and
LCL
ON
OFF
CV
CC
User Diagnostics
"Basic Tests" on page
Local Mode
Output is enabled
Output is disabled
Constant Voltage Mode
Constant Current Mode
Operation
35.
55