Packaging For Shipping Or Storage - Xantrex XPR 10-600 Operating Manual

Installation
Returning Power Supplies to the Manufacturer
Packaging for
Follow these instructions to prepare the unit for shipping or storage.
Shipping or
1. When returning the unit or sending it to the service center, attach a tag to the unit
Storage
2. For storage and shipping, repack the power supply in its original container. If the
3. Label the box as shown below in
4. If shipping, mark the service center address and your return address on the
5. If storing, stack no more than 5 boxes high. Check the storage temperature range
Figure 2.1 Shipping or Storage Carton Label
28
stating its model number (available from the front panel label) and its serial
number (available from the rear panel label). Give the date of purchase and an
invoice number, if you have it, as well as a brief description of the problem.
original container is not available, seal the unit in a plastic bag and then pack it
into a wooden or sturdy cardboard box large enough to allow 2 in. (5cm) of
cushioning material to surround the unit. For cushioning, use material such as
foam slabs that are capable of supporting the unit.
carton.
and storage altitude specification in
POWER SUPPLY
Model Number: _______________________
Serial Number: _______________________
FRAGILE — ELECTRONIC EQUIPMENT
Figure 2.1.
"Environmental Specification" on page 75.
Operating Manual for XPR Series Power Supply