Figure 2.6 Output Voltage Connector - Xantrex XFR 2800 Operating Manual

150 V to 600 V Models
The 150 V to 600 V models have a 4-terminal, wire clamp output connector. See
Figure 2.6 for a labelled drawing of the wire clamp connector. To prepare and
connect the load wiring:
1. Strip 0.4 in. (10 mm) at the ends of the wires.
2. Remove the top part of the output cover. Do not remove the chassis-mounted
3. Loosen wire clamp screws (part of strain relief). Do not disassemble the strain
4. Insert load wire in strain relief.
5. To connect the wiring, loosen each terminal screw, insert a stripped wire into the
6. Tighten the strain relief clamp.
7. Replace the top cover.

Figure 2.6 Output Voltage Connector

Release 2.1
WARNING
To protect personnel against accidental contact with hazardous voltages, ensure
that the load, including connections, has no live parts which are accessible. Also
ensure that the insulation rating of the load wiring and circuitry is greater than or
equal to the maximum output voltage of the power supply.
part of the cover.
relief.
terminal, and tighten the screw securely.
(For 150 V to 600 V models.)
Installation
Load Connection
Negative Output/Return (–)
Positive Output (+)
49