Mechanical Specifications - Xantrex XFR 2800 Operating Manual

Mechanical
Specifications
Front Panel V and I Control
Front Panel Voltage Control
Resolution
Front Panel Voltage and Current
Meters
AC Input Connector Type
Input Fuses
Output Connector
Sense Connector
Analog Programming Connector
Chassis Ground
Cooling
Mounting
Weight
Approvals
1.
Release 2.1
1
Fuses are located on the A4 PCB (printed circuit board). The fuses are
NOT operator-replaceable.
Features and Specifications
10-turn voltage and current potentiometers
0.02% of maximum voltage
3.5-digit green numeric LED displays. For accuracy
specifications, see Table 1.4 and Table 1.5.
3-terminal 34 A, 250 V, right angle, PC mount, wire
clamp connector with removable strain relief cover
1 A, 250 V, 5 x 20 mm slow fuse (T), location: F34;
1.5 A, 250 V, 5 x 20 mm time delay (T), location: F33;
20 A, 250 Vac, 5 x 20 mm fast high interrupt (F),
location: F36;
30 A, 300 Vac, 10.3 x 41.3 mm medium time lag (T),
locations: F2, F3.
7.5 V to 100 V models: nickel-plated copper bus bars
with removable bus bar shield; bus bar holes: 0.343 in.
(8.7 mm) diameter (D) (1), 0.197 in. (5.0 mm) D (2);
150 V to 600 V models: 4-terminal, right angle, PC
mount, wire clamp connector with removable strain
relief cover.
5-terminal wire clamp connector (2 piece)
15-terminal wire clamp connector (2 piece)
One chassis ground screw located on rear panel for
bonding connections or for wire shield grounding.
Maximum penetration into unit is 0.375 in. (9 mm).
Fan cooled. Air exhausts to rear. Over temperature
shutdown: automatic restart or latch off
(switch-selectable).
Rack mount brackets. Mount at front panel.
Approximately 33lb. (15 kg)
CE-marked units are approved to IEC 1010-1 safety
standard and EN50081-2 and EN500082-2 EMC
standards, and are CSA certified to C22.2 No. 1010.1.
CE-marked units are also approved to U.S.
requirements of NRTL/C and are UL listed to
UL3111-1, 1st edition, (up to 40 °C). Additional
standards met: FCC, part 15, class A EMI standard.
Specifications
33