Xantrex XFR 2800 Operating Manual page 23

Table 1.2 Rear Panel SW1 Switch Assignments
Switch
SW1-1
SW1-2
SW1-3
SW1-4
SW1-5
SW1-6
SW1-7
SW1-8
1. Factory defaults underlined.
Resetting the Switches Before making any changes to the switch settings,
disable the power supply output by pushing the front panel STANDBY switch to its
IN position. This temporarily shuts down the power supply. The front panel S/D
LED turns on. Then, use any small, flat-bladed screwdriver to change the switch
settings.
Any of the eight switches on SW1 is OFF when it has been flipped up to break
contact, ON when flipped down to close contact.
Release 2.1
Function
1 mA current source for resistive
programming of output voltage
1 mA current source for resistive
programming of output current
limit
Output voltage programming
source range select
Output current limit programming
source range select
Output voltage monitor range
select
Output current monitor range
select
Remote shutdown logic select
Over temperature shutdown reset
mode select
Features and Specifications
Rear Panel Connectors and Switch
1
Open Closed
Voltage source Resistive programming
programming (0-5 k, 0-10 k)
Voltage source Resistive programming
programming (0-5 k, 0-10 k)
0-5 V (0-5 k) 0-10 V (0-10 k)
0-5 V (0-5 k) 0-10 V (0-10 k)
0-5 V 0-10 V
0-5 V 0-10 V
HIGH=OFF HIGH=ON
Auto reset Latch OFF
21