Figure 2.4 Output Strain Relief And Cover - Xantrex XFR 2800 Operating Manual

Output Cover The power supply comes with a bus bar cover and strain relief. See
Figure 2.4. This cover is also installed on models fitted with the high voltage output
connector.
To detach the 2-part cover:
1. Undo 6-32 x 5/16 in. Phillips pan head screws, 6 x 0.288 in. lock washers, and 6
2. Pull up on the top cover to remove it.
3. Undo 6-32 x 1/4 in. Keps nuts and 6 x 5/16 in. flat washers from the
Screw, Lock
Washer, and Flat
Washer
(3 places)
Keps Nut and
Flat Washer
(3 places)

Figure 2.4 Output Strain Relief and Cover

Release 2.1
x 5/16 in. flat washers (3 places) from the top cover.
chassis-mounted PEM studs (3 places) to remove the chassis cover.
Chassis Cover
Top Cover
Installation
Load Connection
Wire Clamp
and Screw
Strain Relief
47