Ethernet (ENET)
Overview
This chapter is intended for network administrators responsible for the
configuration and maintenance of devices on the network. This chapter
provides information for connecting and configuring the power supply to
Ethernet.
Basic Section
This section describes the equipment and procedures to fully set up the
simplest configuration of an XTR unit with the ENET option and a single
computer.
Important:
Section" on page 2–25. Xantrex recommends that you read through this section
even if the configuration doesn't match your final setup.
System Requirements
•
•
•
•
Accessories
•
•
•
•
Communication Cable
Use a standard RJ-45 (see Figure 2-1) and RJ-45 cross-cable (see
Figure 2-2).
Figure 2-1 Computer or HUB Plug
2-2
The information in this section is applicable to the "Advanced
Windows XP, Windows 2000, Windows NT4.0 (with service pack
6.0a or later), Windows ME, or Windows 98
Internet Explorer 5.01 or later
30 MB hard drive space
64 MB RAM
Power supply with ENET port
ENET RJ-45 and RJ-45 STP, Cat 5 cross-cable 9.84 feet (3 m) in
length or longer⑧
PC
Installation CD
M370046-06