Switch Indicator For Door State (Door Sensor) - Delta PCS100 Maintenance Manual

Installing a G Board
1. Align the posts on the front door with the keyholes on the G board.
2. Slide the G board to lock in place.
3. Secure the G board with screws.
4. Connect the cables to the L board.
5. Close the front door. See "Closing a Front Door" on page 22.

Switch Indicator for Door State (Door Sensor)

WARNING!
!
Read the "Safety Instructions" on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
!
D
ANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED
D ,
EATH SERIOUS INJURY
Maintenance Manual
Figure 83. Installing a G Board
,
OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN
64
Maintenance
. D
O NOT OPEN THE
.
.