Lcd Module - Delta PCS100 Maintenance Manual

Installing an L Plate
The following procedure assumes that the LCD assembly, see "LCD Module" on page 60, is already
installed on the L plate.
1. Locate the front side of the L plate assembly to expose the LCD module.
2. The cable sockets are visible at the bottom of the assembly. Connect the required cables to the
sockets. Take care to not pull the LCD assembly out to prevent damaging the cables or the con-
nector pins.
3. Gently turn the LCD assembly around so that the LCD module faces the front door and align the
top holes on the plate to the standoffs on the front door.
4. Insert the holes in the L plate into the standoffs until the plate is flush in the front door.
5. Slide the plate down until the screw holes are visible through the plate.
6. Secure the plate with screws.
7. Close the front door. See "Closing a Front Door" on page 22.

LCD Module

The LCD module is visible from the front of the front door. It is accessible for service from the interior
and located behind the L plate, see "LCD Plate" on page 58.
WARNING!
!
Read the "Safety Instructions" on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
!
D
ANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED
D ,
EATH SERIOUS INJURY
Maintenance Manual
Figure 79. Installing an L Plate
,
OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN
60
Maintenance
. D
O NOT OPEN THE
.
.