Ac And Dc Switch Handles - Delta PCS100 Maintenance Manual

AC and DC Switch Handles

The AC and DC switch handles are housed on the front door. To facilitate maintenance on the AC and
DC switch handles, you will need access to both the internal and external sides of the front door.
The bus capacitor discharge time is 15 minutes. Before starting any maintenance, switch power off,
wait for more than 15 minutes, and check for residual voltage with a meter etc., to avoid a hazard of
electrical shock.
WARNING!
!
Read the "Safety Instructions" on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
!
D
ANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED
D ,
EATH SERIOUS INJURY
Important Safety Instructions
It is important to remember that the PCS100 is designed to supply power even when it is disconnected
from the power grid. The interior of the PCS100 is unsafe until the DC power source is disconnected
and the AC/DC inputs are disengaged. It is recommended to wait a period of at least five minutes for
capacitor bleed-off before attempting to service any components.
Note:
 Maintenance should only be performed by qualified personnel.
 Lethal voltage is present in the PCS100. The unit must not be operated with the front
door doors open. At no time should you make any assumptions of the electrical state of
the PCS100.
Before attempting any work around the PCS100, observe the following precautions:
 Remove any watches, rings, or other metallic accessories.
 Only use tools with insulated handles.
 Wear rubber gloves and boots.
 Do not lay tools or metal parts on top of the cabinet.
Maintenance Manual
,
OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN
45
Maintenance
. D
O NOT OPEN THE
.
.