Delta PCS100 Maintenance Manual page 50

1. Continue with the AC extension rod, align the base of the rod to the socket. The base of the rod
is design to fit on the socket in a specific alignment.
2. Insert the hexagonal screw in the screw hole on the rod and turn it to thread it in place.
3. Insert a hex-key wrench in the screw and turn it to secure the rod to the socket.
4. Align the safety bracket on the chassis. The flat side of the bracket protrudes into the inner side
of the cabinet. If properly aligned, the holes on the bracket and chassis column align.
5. While holding the cover bracket, insert the screws and tighten them to secure the cover bracket.
Maintenance Manual
Figure 46. Installing an AC Extension Rod
ON
OFF
Figure 47. Installing a Safety Cover Bracket
38
Maintenance
ON
OFF