Delta PCS100 Maintenance Manual page 63

Installing a DC-Side Fan Module
1. Face the fan module so that it's sticker label is visible through the opening in the fan bracket.
Position the fan cable so that it protrudes through the side facing the cable bracket.
2. Insert the fan module in the bracket making sure that the screw holes are aligned.
3. Insert a screw through a hole in the fan module then secure it with a screw driver. Make sure the
cable does not sit underneath the fan module. If the cable is underneath, gently pull it through
the end of the bracket.
4. Continue with the remaining screws.
5. Align the fan assembly over the bolts on the chassis and insert the bracket in place.
6. While holding the fan assembly in place, insert a nut on the bolt and turn it halfway.
7. Insert the second nut in place and tighten both nuts to secure the assembly.
Maintenance Manual
Figure 66. Assembling a DC-side Fan Assembly
Figure 67. Installing a Fan Assembly
51
Maintenance