Module Control Board (M Board) - Delta PCS100 Maintenance Manual

5. Align the holes on the wires with the holes on the D board.
6. Secure the wires and D board with screws.
7. Close the control box. See "Closing a Control Box Cover" on page 32.
8. Close the front door. See "Closing a Front Door" on page 22.

Module Control Board (M Board)

WARNING!
!
Read the "Safety Instructions" on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
!
D
ANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED
D ,
EATH SERIOUS INJURY
Important Safety Instructions
It is important to remember that the PCS100 is designed to supply power even when it is disconnected
from the power grid. The interior of the PCS100 is unsafe until the DC power source is disconnected
and the AC/DC inputs are disengaged. It is recommended to wait a period of at least five minutes for
capacitor bleed-off before attempting to service any components.
Note:
 Maintenance should only be performed by qualified personnel.
 Lethal voltage is present in the PCS100. The unit must not be operated with the front
door doors open. At no time should you make any assumptions of the electrical state of
the PCS100.
Maintenance Manual
Figure 191. Connecting the Wires
,
OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN
128
Maintenance
. D
O NOT OPEN THE
.
.