Auxiliary Heat Exchanger Power Board (G Board) - Delta PCS100 Maintenance Manual

Installing a LCD Module
1. Situate the LCD module over the L plate. Take note of the terminal block socket and connector.
2. Install the bolts and LCD module.
3. Secure the LCD module with screws.
4. Install the L board. See "Installing an L Plate" on page 60.
5. Close the front door. See "Closing a Front Door" on page 22.

Auxiliary Heat Exchanger Power Board (G Board)

WARNING!
!
Read the "Safety Instructions" on page ix on the first at the beginning of this manual before
performing any service on the components. Ignoring safety instructions may result in injury,
damage or death.
CAUTION!
!
D
ANGEROUS VOLTAGE LEVELS MAY BE PRESENT FOLLOWING DISCONNECTION
CABINET UNTIL A REASONABLE PERIOD OF TIME HAS ELAPSED
D ,
EATH SERIOUS INJURY
Maintenance Manual
Figure 81. Installing an LCD Module
,
OR HARDWARE DAMAGE CAN RESULT IF CAUTION IS NOT TAKEN
62
Maintenance
. D
O NOT OPEN THE
.
.