3.6
Re-activating Alarms
Alarms that have been paused and whose activation conditions continue to exist can be reactivated.
To reactivate alarms, proceed as follows:
1. Press the MENU
displayed.
2. Press the DOWN
already
the case. Refer to the following graphic:
3. Press the ENTER
4. Press the UP
following graphic:
5. Press the ENTER
•
A "beep" sounds.
•
An audible alarm sounds.
•
An alarm indicator illuminates.
•
The messages of all active alarms are displayed in a loop in the Ventilation and Alarm
menus.
•
The Audio Paused symbol
•
The Alarm Paused symbol
User's Manual
key to access the Alarm Setting menu, if this is not the menu currently
key to position the cursor on the "Alarm Logs" line, if this is not
Figure 3-6. Reactivating Alarms
key, to confirm access to the "Alarm Logs" menu.
key to position the cursor on the "USER'S CLEAR ALERTS" line. Refer to the
Figure 3-7. Alarm Logs
key for at least three (3) seconds. The following events occur:
disappears (if it was displayed).
disappears.
Alarms and Troubleshooting
3-7