Vertical SBX IP 320 Installation Manual page 78

Basic Programming
Flexible Numbering Plan (PGM 105)
To set the Flexible Numbering Plan, perform the following steps:
1. Press the [TRANS/PGM] button + 105.
2. Enter the Station Range (dial the Start and End numbers as described in the Table).
3. Press the [HOLD/SAVE] button to accept changes.
Table 6-4 Numbering Plan Detail
STATION NUMBERS
000
100
000
100
000
100
001 002 003 [TRANS/PGM] + 105
101 102 103
001 002 003 Station Number Assign-Four station numbers correspond to the 4
port numbers. The Station number length is in the range of 2 digits
101 102 103
through 4 digits. There are two methods for changing the station
number:
Dial two station numbers - Dial the range of the start and end
Station numbers. The LCD will show the dialed range value. Press
the [HOLD/SAVE] button to accept change. All LEDs of BTNs
will be extinguished.
Press one of FLEX 1-4 - Each FLEX button (1-4) is assigned to a
corresponding Station number (1- 4) on the current LCD. The LED
of the pressed Flexible button will show steady light. Dial the new
Station number and press the [HOLD/SAVE] button to accept
change, or press another Flexible button to assign a Station number
to other stations without saving.
To change the next 4 station numbers then press [ ] button. If you
want to change previous 4 station numbers, then press [ ] button.
To delete all Station numbers, press the [SPEED] button and press
the [HOLD/SAVE] button; all station numbers will be cleared.
001 002 003 Press the [HOLD/SAVE] button to save changes to the database
permanently (Ex: Press FLEX 2, dial 400 and press [HOLD/SAVE]
400 102 103
button).
DESCRIPTION
SBX IP 320 Installation Guide
Chapter 6: Starting the SBX IP 320
-
6 10