Vertical SBX IP 320 Installation Manual page 127

[Commands] Menu
Monitor - Set Device Trace
Sets trace for device.
Command options are as follows:
Device options are as following:
If you want to trace the Station 102 about Cmd, Evt and Hiway information, you should enter
the command option with physical station number as following;
At the Sxxx, xxx should be physical station number, i.e., port number of station. So, even if the
station number was changed from 102 to 702, the physical station number is not changed;
Monitor - Dump Memory
This command dumps memory between the two addresses, which are in hexa decimal format.
If you omit one of the two address ranges, memories are dumped beginning at the address
specified until pressing Ctrl+C.
Monitor - Modify Memory
This command modifies memory beginning at the address until pressing Ctrl+C.
c : device COMMAND tracing. (MP PP)
e : EVENT tracing. (PP, Internal, Timer Event)
h : HIGHWAY tracing.
t : CTI device command / event tracing.
S : Tracing related to station
C : Tracing related to CO
D : Tracing related to DTMF
T : Tracing related to CPTU
V : Tracing related to VMIB channel
mon>t ceh s002
mon>t ceh s002
SBX IP 320 Installation Guide
Chapter 9: Remote Diagnostics
-
9 27